Product Description:
Buttons:
- Short press: confirm the measurement and send to the APP via Bluetooth
- Short press: power on/off
- Short press: switch between inches and centimeters
Install the battery:
- Press and rotate the battery door anticlockwise . Battery door will be open. Insert the battery. Make sure the positive pole face up.
- Close the battery door clockwise.
How to use:
Short press power button “on/off” button , turn it on. Bluetooth is not connected if the Bluetooth, icon flashing continuously.
- Pull the tape and wrap it around the body part.
- Insert the locking pin into the tape receptacle.
- Press and hold the ADJUST button until the tape has fully retracted around the body part.
Press tick to confirm the measurement and send it to the APP. The Bluetooth icon on display will flash twice.
Caution:
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsibIe for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and (2) this device must accept any interference received , including interference that may ca use undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a CIa ss B digital device, pursuant to Pa rt 15 of the FCC Rules. These limits are desig ned to provide reasonable protection against h armful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and , if not installed and used in accord ance with the instructions, may ca use ha rmful interference to radio communications. However, there is no gu arantee that interference will not occur in a particula r installation.
If this equipment does cause h armful interference to radio or television reception, which can be determined by turning the equipment off and on , the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipmen I and receiver.
— Connect the equipment in to an outlet on a circuit different from that to which the receiver is connected .
— Consult the dealer or an experienced radio/TV technician f
Technical data:
| Unit | cm/in |
| Accuracy | 2% |
| Resolution | 1mm |
| Measuring Ra’ge | 1500mm |
| Working Temperature | -0°C – 50°C (32°F-1.22° F) |
| working Humidity | <g5% |
| Battery | CR2032 |
Note: To read the complete user manual, please download the following file: