For optimum performance from this product, please read this manual and supplied safety information booklet carefully before use.
Do not use this radio or charge the battery in an explosive environment, such as gas, dust, smoke, etc. Do not leave the radio in a dusty or wet environment. It is very important for the user to understand all instructions before using the radio.
Device Checking:
Thank you for purchasing this portable transceiver.
Before using:
- Please check whether the packing box is damaged or not.
- Please unpack packing box carefully and confirm the following list of items are in the box. If any items are missing or have been damaged using shipment, please contact radio supplier immediately.
Supplier accessories:
| Item | Quantity |
| Transmitter | 1 |
| Antenna | 1 |
| Li-ion battery | 1 |
| Charger | 1 |
| Battery clip | 1 |
Familiar with the transmitter:
Screen Icon:
Function and operation instruction:
Transmitting:
Press the PTT and transmit the signal at current channel, the indicator light turns red and the signal bar lights. If the transmitting power is high, the signal bar is fully light If the transmitting power is low, the signal bar does not light fully.
Receiving:
When the device receives the same frequency signal and matches the same CTCSS, the indicator light turns green, the speaker has audio and the receiving status and signal bar light at the same time.
CTCSS/DCS Setting:
Enable sidekey1 or sidekey2 to have CTCSS/DCS function via software, press the relevant key to enter the CTCSS/DCS manual setting. The screen will display the matched code with current channel, please refer to CTCSS/DCS table CTCSS indicator and DCS indicator light at the same time, which means no CTCSS/DCS code at current channel.
CTCSS indicator light which means having CTCSS code at current channel.
DCS indicator light which means having DCS code at current channel.
Changing the current CTCSS/ DCS via channel switching key, long press the key to fast changing the code then press side key 1 to confirm the setting, press side key 2 to cancel and exit the setting.
Monitor:
Enable side key 1 or side key 2 to monitor function, press the relevant key to enter the receiving status then monitor the same signal with the current channel.
Scanning:
Programming side key 1 or side key 2 to scan function, long press the relevant key to enter the scanning status, the scan icon lights and the scanning starts.
Power Selection:
Programming the side key 1 or side key 2 to high power selection function, long press the relevant key to change the current power. Select the transmitting power accordingly to make sure that battery is used reasonably.
Emergency alarm:
Programming the side key 1 or side key 2 to emergency alarm function, long press relevant key to transmit the alarm signal to the device which is with same frequency.
Keypad lock:
The keypad will be locked when the device unused for a certain time, and the keypad lock icon shows on the screen at the same time. Keypad can be unlocked by long pressing the channels switching key or pressing the PTT button.
NOAA:
Programming the device to open the NOAA function, the NOAA icon lights . When the device is under standby status, it will receive the NOAA signals at the same time. When the device receives the 105 Hz alarm signals, the NOAA status will show on the screen receive and broadcast alarm signal . Press the PTT button to exit the NOAA status. Programming side key 1 or side key 2 to NOAA function long press the relevant key to enter NOAA signal.
NOAA Table:
CTCSS Table:
DCS Table:
Note: To download the complete user manual, please download the following file: