Important Safety Instructions
- Read these Instructions.
- Keep these Instructions.
- Heed all Warnings.
- Follow all instructions.
- Do not use this apparatus near water.
- Clean only with a dry cloth.
- Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifier) that product heat.
- Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
- Only use attachments/accessories specified by the manufacturer.
Additional Warnings and Precautions
- Do not look directly into the projector light.
- Don’t touch the project lens
- Mains adapter is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected from the mains socket outlet completely.
- CAUTION: Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure.
- WARNING: Changes or modified to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
In The Box:
- Carrying Case
- Main Unit
- Lens Cover
- Remote
- AC Power Adapter
- AV Cable
- USB (Type C) cable
- User Manual
Remove & Close The Lens Cover:
To reduce Image Distortion
- Move the projector as close to the center of the screen as possible.
- The light beam from the projector should be perpendicular to the screen for a rectangular or square image.
Installing your Projector in the Ceiling
When installing the projector in the ceiling, please purchase a projector mount recommended by an installation professional and follow the instructions that come with the mount.
Before installing the projector in the ceiling, please check to make sure the ceiling structure can support the weight of the projector and the mount. If in doubt, please ask the advice from an installation professorial.
Controls of Remote:
Install / Remove Batteries of Remote:
Remove the battery compartment cover on the back of your remote by carefully sliding to open. The battery cover can then be lifted away. Fit the correct batteries (not included), referring to the polarity markings. Finally, replace the cover.
Controls of Carrying Case:
- Handle
- Cover lock
- AUX in Jack
- DC in type C Jack
- Charge Indicator
- Power Indicator
- Volume –
- Volume +
- Carrying case power on/off
Connect AV Show The Image On Projector Screen
Follow below picture to connect AV cable and device.
- Turn off the unit before connect AV cable.
- Use AV cable to connect follow below figure
- After connect, press the power button to turn on unit and power indicator will light GREEN
- Press the SOURCE button to select AV mode and the video of AV device will show on projector screen
- Press the power button to turn off unit power.
Connect Audio Output ( Aux Out / Line Out / Earphones)
Follow below picture to connect audio cable and device.
- Press the power button to turn off power of your projector before connection.
- Use audio cable to connect follow below figure.
- After connect and turn on both units. Your projector sound from external device now.
- After using , turn off both unit.
Specifications:
| Light Source Type | LED |
| Display Native Resolution | 1280 x 720 RGB |
| HDMI Input Supported Video Resolution. | 1080p , 1080i , 720p, 576i , 480p, and 480i |
| Power Consumption | 70W |
| Included Adapter | Input AC100-240V, 50/60Hz Output DC26V, 2.3A |
| Projection Size | 36-150 inch |
| Input Port | AV/ VGA / HDMI |
| USB Port | Support USB device up to 32GB Support format Mpeg1, Mpeg2, Mpeg4, mp3, Jpeg |
| TF Card | Support SD card up to 32GB Support format Mpeg1, Mpeg2, Mpeg4, mp3 , Jpeg |
| Net Weight | 1.2 KG (Projector unit) |
| Product Dimensions | 240 x 184 x 94 mm (Projector unit) 300 x 296 x 118 mm (Carrying Case) |
Note: To download the complete user manual, please download the following file: