PHILLIPS CONNECT TECHNOLOGIES Battery Operated LTE Cellular GPS Tracker
INTRODUCTION
The Battery Operated LTE Cellular GPS Tracker from Phillips Connect Technologies is a vehicle tracking device that combines GPS location with LTE and Bluetooth. The Smart7 Lid monitors vehicle functions and collects data for tracking and analysis.
The Smart7 Lid appears to the user of a server application as a single endpoint device. It can be queried, updated, and configured either through a serial connection or an over-the air (OTA) LTE IP connection. The Smart7 Lid presents itself over the connections as an enhanced cellular modem with attached functional elements. These elements include:
- GPS location engine
- General Purpose Bidirectional I/O (GPIO) pins
- Relay drive pin output
- Serial UART port
- CAN Communication (optional)
Technical Specifications
The Smart7 Lid ships from the factory pre-configured for a specific set of functions and is completely configurable in the field, while providing support for external control through a Phillips Connect proprietary set of AT commands. Supported features include the following:
CELLULAR GATEWAY
An integrated cellular gateway provides continuous 4G-LTE connectivity to the trailer. A multi- carrier SIM assures comprehensive coverage.
- 4G-LTE Cat-1(bands 2, 14, 12)
- 3G-HSPA fallback (bands II, V)
- Roaming w/VPN onto TMO, ATT, VZ
- Canada, LatAm plans available ƒ Secure reports delivery with ACKnowledge
- Report queue size: 2000
- OTA update of all firmware components
- OTA update of compatible sensors
REPORTING
- 1- to 5-minute breadcrumbs (configurable)
- Heading changes
- Sensor data and alerts Reporting while stopped includes:
- Daily heartbeats (configurable)
- Vibration / motion-detection
- TPMS and Tilt alerts
- Tractor pairing
- Door open/close
- Cargo status change
- PreCheck alerts
- Current ABS Fault Code
GPS / LOCATION TRACKING High performance GPS tracking means you always know where your trailers are located.
- 25mm x 25mm sky-facing ceramic patch antenna
- GPS L1 band 1575MHz
- GPS-based odometer accuracy: > 99.5%
INTEGRATED ABS MONITORING (THROUGH PLC)
Compatible with most ABS manufacturers.
- Retrieved ABS data includes:
- Fault lamp status
- DTC trouble-codes (active & stored) ƒ Odometer
- VIN (if programmed into ABS)
TRAILER PRECHECK
Know what to expect before the driver arrives with Schedule-based or Remote-On-Demand PreCheck of trailer sensors… or conduct an onsite live PreCheck prior to tractor hookup.
- 1A @ 12V supply for external sensors
- External sensors include TPMS, cargo, ABS, trailer-weight, and more
BLUETOOTH WIRELESS SENSOR SUPPORT
- Bluetooth 5 LE class II transmitter
- Receive sensitivity -96dBm
- Compatible sensors include:
- SmartPairTM,Door✓TM
- SmartLock gladhand o MicroSPTransceiver
HARNESS INTERFACES
- Optional data harness for additional wired sensors using RS485, UART, or GPI
BATTERY PACK AND POWER SUPPLY
- 10.6A-Hr recharge-able Li-ion battery pack
- ~6 months untethered operation
- 4hrs to 90% charge from either Aux or Marker circuit power
- 360mA integrated solar panel
- Maximum 2A current draw from tractor
- Tracking mode: 50mA battery current
- Idle mode: 2mA battery current
- Sleep mode: 100μA battery current
PHYSICAL DIMENSIONS AND MOUNTING
- Length 13.6” x Height 7” x Depth 4.1”
- Mount with 2 x 5/16” bolts
ENVIRONMENTAL
- IP67 protection for electronics and battery
- Operating temp. range: -40C to 70C
- Battery charging temp. range: -20C to 45C
CERTIFICATIONS
- FCC/IC
- BQB Bluetooth
- PTCRB cellular
- RoHS compliant
Technical Data
FRONT/REAR DIMENSIONS
Download Phillips GPS Tracker User Manual
Contact Information:
Technical Support
1-833-213-5839 Support@Phillips-Connect.com
Sales
1-833-213-5839 PCT-Sales@Phillips-Connect.com