Charging the rechargeable battery pack for the RC vehicle:
1. Locate a USB certified port from any of the devices. The LED indicator inside the USB Cable
will turn green.
2. Connect the 6.4V Li-ion rechargeable battery pack and the USB Cable connectors, then the LED indicator will turn off to show that it is charging.
3. Once the LED indicator turn green again, the battery i.e fully charged. It takes around 1 hour to fully charge the battery. However, even the LED does not turn green, do not charge the battery mora than 2 hours.
4. When charging ia completed, detach the connectors from battery pack and USB certified port.
Note: If the LED twinkle slowly, then the USB Cable is not able to work properly. Try to connect the USB Cable to another USB port, if the problem persist, immediately disconnect the battery arid the USB Cable and seek replacement.
Battery Installation for the controller:
- Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included).
- Open the battery cover
- Install 2 new 1.5V ‘AA’ LR6/Ra battery with correct polarity (+/-) aa shown inside the battery compartment.
- Install the battery cover and then tighten the screw on the battery cover.
Battery Installation for the vehicle:
- Switch the power OFF.
2. Rotate the battery cover latch aaide and open the battœy œver.
. Install s.cv u-ion rechargeable battery into the battery apartment. Connect the rechargeable battery pack to the aocket in the battery compartment.
- Install the battery cover and turn the latch to lock it in position.
- The “Power LED” on the vehicle will not flash nor stay on if the rechargeable battery has run out power.
How to play:
1. Set the “Power Switch” on the controller arid vehicle to ON position, the “Power LED’ on both the controller and vehicle will flash led then 3 second then stay on, meaning the automatic frequency matching between the controller and the vehicle i-e completed.
2. If the ’Power LED” of the controller or the power LED of the vehicle flash more than 3 seconds, switch off both the vehicle and controller, then turn them on again.
3. Pull the bigger in the transmitter half way to drive the vehicle forward. Pull the trigger full way to obtain extra speed. Puah the trigger in the transmitter to drive the vehicle backward. Turn the steering knob in the transmitter to steer the vehicle to right or left.
4. If the vehicle went too far arid out of control, switch off both the vehicle and
5. If the vehicle does not run in a straight line, adjust the wheel alignment under the chassis.
6. Turn the switch off the controller and vehicle to OFF position when not in play.
Performance Tips:
1. Do not drive the vehicle on graae, and or go through water.
2. Do not drive the vehicle in windy or rainy weather.
3. Do not drive the vehicle into any hard object.
4. Keep fingers, hair and loose clothing away from the vehicle.
5. The operating range can be affected by a variety of factors:
a) Weak controller or vehicle batteries.
b) Interference from other items that emit radio frequency signal.
6. Outdoor usage is recommended in order to get optimal control range.
7. Remove the package, take out all accessories and assemble the product before giving it to children to play.
Cautions:
- The 4V Li-ion battery pack must be charged before use.
- Use only the battery pack and USB Cable that came with this vehicle. Do not overcharge the Battery Pack. Do not charge for more than 1 hours except for the initial two charges.
- Do not charge the Battery Peck if it shows leakage, corrosion, or has loose or exposed wires or other damage.
- Do not cover the Battery Pack with any sort of material while charging.
- Do not touch the Battery Pack when it is hot. Wait until the Battery Pack cools before installing it in the Vehicle and before recharging. Do not dispose of the Battery in fire.
- Do not dismantle the Battery or USB Cable, and do not cut the Battery or USB Cable.
- The Battery Pack will be warm after charging, and hot after use in a Vehicle.
- The imply terminals area not to be short-circuited.
- Rechargeable Batteries are to be removed from the toy before being charged.
Package Included:
- RC Vehicle x 1
• Controller x 1
- USB Cable x 1 (Input: DC 5V 2A Output: DC 6.4V 1A)
- 6.4v Li-ion Rechargeable Battery Pack (For Vehicle Use) x 1
- 1. 5 V AA ‘ LR6/R6 non-rechargeable Battery (For Controller Use) x 2
• Owner’s Instruction Manual x 1