Product Introduce:
Face Panel
Specifications
| Model | AirQM-9 |
| Size | 150*66*49.2mm (non-include power plug) |
| Net Weight | |
| Input Power | 110~240V-0.1A, 50/60Hz |
| Operation Ambient | Indoor Use Only Temp:-10℃~60℃ Hum: 0-90% non-condensing |
| Network Connection | Wi-Fi IEEE 802.11b/g/n 2.4GHz |
Operations:
Insert the device to the power socket and the display show a ten-second countdown. The device starts to work normally when the countdown end.
- Attention:
To ensure the data accuracy of the measurement, please keep the device’s orientation as the picture and working in a well-ventilated place.
Configuration
Enter Network Configuration Mode
Press the Switching Button for several
seconds after power on, and release the
button after buzzer is on. The Wi-Fi icon
should flash slowly in the upper right
corner of the display, then the device
enters the network configuration mode.
Connect the Device with Mobile
phone
Enter WLAN setting of mobile
phone, search Wi-Fi ‘airbox_device’
and select.
Enter Network Configuration Interface
After the mobile phone is connected to the
device’s Wi-Fi, open the phone browser
and input 192.168.4.1 in the address bar to
enter configuration interface.
Fill in the Configuration Information
Input Wi-Fi SSID, password and other
network configuration parameters in the
Connect NetWork interface. And click
the Config button to finish.
Display Description:
Measuring Type Switching
The Display just can show one
measurement data only, click the
Switching Button to change the
display parameter.
Status Indicator Description:
AIRQM-9 Air Quality Monitor User Manual
https://fccid.io/2A328-AIRQM-9/User-Manual/user-manual-5603498.pdf
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance of 20cm the radiator your body. This device
and its antenna(s) must not be co-located or operation in conjunction with any other
antenna or transmitter.