Pairing A305 Earbuds- Using Charging Case
1. Take out earphones from the charging case
2. Select ‘ENACFIRE Geek’ from Bluetooth list
Pairing A305 Earbuds- Without Charging Case
1. Power On: Touch the earphones for 1 second. Release when you hear the prompt sound ‘Power on! with Blue light on.
2. Palring: Earphones will pair automatically with Right earphone Blue and White light flash alternately
3. Select ‘ENACFIRE Geek’ from the device’s Bluetooth list
Note: Right earphone Is the master earphone
Product Overview
ENACFIRE Geek A305 Images
Package Contents
Answering Calls
Answer call/End call
Tap the Left/ Right earphone once
Reject call
Touch the Left / Right earphone for 2 seconds
Music Controls
Pause/ Play
Tap the Left/ Right earphone once to pause/ play music in the music mode
(Some phones may require to start a media player first)
Voice Assistant
Tap the Left/ Right earphone 3 times, your device’s Voice Assistant will be activated with the ‘Beep’ prompt sound
Next song
Double-tap the Right earphone
Previous song
Double-tap the Left earphone
Change Volume
Touch and hold the Left earphone to decrease volume Touch and hold the Right earphone to Increase volume.
Note:
Above functions are not supported when the earphone is used in single. Prompt sound ‘Beep’ will be produced when the volume reach minimum or maximum level.
Powering Off
With Charging Case
Put the earphones back to the charging case, they will power off automatically.
Note: Put only the Left earphone into the charging case, the Right earphone will stay connect.
Put only the Right earphone into the charging case, the Left earphone will disconnect and start pairing.
Without Charging Case
1. Turn off Bluetooth to disconnect the earphones
2. Touch either one earphone for & seconds to power off both earphones
Single Mode
Note: There will be two ‘ENACFIRE Geek’ Bluetooth names for Left and Right earphones. Please select accordingly.
Charging
Earphones Charging Status
Earphones white LED light on: Charging Earphones white LED light off: Fully charged
Note: It takes about 1.5 hours to fully charge the earphones
Charging Case Charging Status
Lights on charging case stands for the remaining battery capacity
Note: It takes about 1.5 -2 hours to fully charge the charging case
Troubleshooting
Please follow below steps when both earphones fal to palr each other or occur connection related Issues
1. Place both earphones to charging case and remain charging
2. Touch and hold the power buttons of both earphones for 8 seconds until Blue and White lights flash
3. Wait for 5 seconds, take out both earphones from charging case
4, Delete the ‘ENACFIRE Geek’ Bluetooth name from your phone and turn off Bluetooth
5, Turn on Bluetooth and click ‘ENACFIRE Geek’ from your phone
Q: Why the music cuts in and out sometimes?
A: Please make sure there is no obstacle between the earphones and your device. Please make sure there Is no Microwave oven /Wifi transmitter around you, which are more likely to produce electromagnetic interference and result in signal interruption.
Note: Please keep your phone and the earphone as close as possible to ensure a more stable Bluetooth connection.
Q: What should |do if the earphones stop charging?
A: We recommend you to charge the earphones by using our cable. If our cable do not work, please try to use another charging cable or power source to charge the earphones.
Download User Manual
ENCFIRE Contact Information
If you have any Issue with the product, please contact us via support@enacfireglobal.com (US/CA) /moongu@enac- fireglobal.com (UK). We will reply to you within 24 hours and 100% solve your issue.