WD Toys Amphibious Stunt Car User Manual

by

Battery Installation:

Replacing batteries of the transmitter:

Find a tool about the same size as the aperture of the remote control cover, align it with the aperture and press it down. At the same time, pull the battery cover back to remove it.

User 2 AA’ size batteries ( Not included)
USB Line
OFF/ON: Requires 7.4V
Stunt Car Look

The Basic Operation of The Products:

forward
backward
Left
Right
360 Rotation
Stunt car back

BATTERIES

  1. Use 1 set of rechargeable battery for the car and 2 pieces of 1.5V “AA” batteries for the controller.
  2. Charging time of rechargeable battery: 3-4 hours
  3. Playing time of rechargeable battery: More than 30 minutes 4.If the car is idle for a long time, please remove the batteries from the car and controller.

PARAMETER

  • The remote control distance is about 150-200 FT.
  • The car size: 9.65×8.1×7 inches
  • The remote control size: 4.84×4.6×1.66 inches 3.Battery capacity: 7.4V 900 mAh 6.66wh.

Charge Notice:

  1. Press the switches on the four groups of knobs for fixing the battery cover , and then remove the battery pack from the battery box.
  2. Insert the USB plug into the battery pack. Make sure the connection is correct and secure as shown. Plug the USB socket into the USB interface. After full power supply, the yellow indicator in USB cable stops flashing.

Warning:

  1. If another car with the same frequency is running nearby, your car will be out of control.
  2. Never let a child use these products unless battery door is secured.
  3. The toy should be used under the direct supervision of an adult. The toy is imitation of real product, does not provide protection. Please Keep out of young children’s reach.
  4. The toy is a high speed car. Please do not impact to human and animal, or it will cause harm and danger.
  5. The packaging has to be kept since it contains important information.

FCC Caution:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment