PACKAGE CONTENTS:
- 1 x Air Purifier
- 1 x Activated Carbon Filter (Pre-Installed)
- 1 x Preliminary/True HEPA Combination Filter (Pre-Installed)
- 1 x User Manual
Getting to know your air purifier:
A. LED Display
B. Touch-Control Panel
C. Dust Sensor Lens
D. Dust Sensor Cover
E. Filter Indicator Reset Button
F. Button Vent
G. Housing
H. Safety Switch
I. Activated Carbon Filter
J. True HEPA Filter
K. Fine Preliminary Filter
L. Back Cover
SPECIFICATIONS
Power Supply | AC 120V, 60Hz |
Rated Power | 40W |
Effective Range | ≤ 30 m² / 322 ft² |
Operating Conditions | -10°C–40°C / 14°F–104°F |
Noise Level | ≤ 52dB |
Clean Air Delivery Rate (CADR) | 230 m³/h / 135 CFM |
Standby Power | < 0.8W |
Dimensions | 36.8 x 18.3 x 93.5 cm / 14.5 x 7.2 x 18.5 in |
Weight | 6.10 kg / 13.45 lb |
SAFETY INFORMATION
To reduce the risk of fire, electric shock, or other injury, follow all instructions and safety guidelines.
General Safety:
- Only use your air purifier as described in this manual.
- Do not use your air purifier outdoors.
- Keep your air purifier away from water, and wet or damp areas.
- Never place in water or other liquids.
- Keep the inside of the air purifier dry. To prevent moisture buildup, avoid placing in rooms with major temperature changes or underneath air conditioners.
- Keep your air purifier away from heat sources.
- Do not use where combustible gases, vapors, metallic dust, aerosol (spray) products, or fumes from industrial oil are present.
- Keep 5 feet away from where oxygen is being administered.
- Supervise children when they are near the air purifier.
- Do not place anything into any opening on the air purifier, unless directed by the manual.
Buttons:
On/Off Button
- Turns the air purifier on or off.
- Press and hold for 5 seconds to put the air purifier into Configuration Mode.
- Press and hold for 15 seconds to reset to original settings.
Display Off Button
- Turns the display off.
- Press any button (except ) to turn the display back on.
Sleep Mode Button
- Turns Sleep Mode on or off.
Auto Button
- Turns Auto Mode on or off.
Fan Speed Button
- Cycles through fan speeds: low, medium, and high.
- The fan speed cannot be changed during Auto or Sleep Modes.
Timer Button
- Sets or cancels a timer
GETTING STARTED:
- Open the back cover of the air purifier and remove both filters from their plastic packaging.
- First, place the Activated Carbon Filter back into the air purifier. Then, place the Preliminary/True HEPA Combination Filter. Make sure the pull tabs on both filters are facing out.
- Replace the back cover by lining up the cover’s feet with the matching slots on the bottom of the housing. Make sure that the triangular piece at the bottom of the cover is touching the safety switch.
- Push the cover closed.
- Place the air purifier on a hard, flat surface. Leave 38 cm (15 in) of clearance on all sides of the purifier.
USING YOUR PURIFIER:
General Operation:
- Press power to turn the air purifier on/off. The air purifier fan will start automatically at low speed.
- Optionally, press fan speed button to increase fan speed. You can also select Auto or Sleep Mode, or set a timer.
Note:
- For best results, run the air purifier at maximum speed for 15–20 minutes before using a lower speed or Auto Mode.
- To effectively clean air, keep windows closed while the air purifier is operating.
Resetting Your Air Purifier:
- Resetting your air purifier can help you troubleshoot any issues you may have, including if your air purifier has gone offline.
NOTE:
Hard resetting the purifier will erase all of your custom settings and restore the default settings. Delete your air purifier from the VeSync app.
2. Press and hold the power button for 15 seconds or longer.
After 5 seconds, the WiFi indicator light will blink slowly (1 time per second). The air purifier will beep once.
After 15 seconds, the WiFi indicator light will blink quickly (4 times per second). The air purifier will beep again. Then, the WiFi indicator light will blink rapidly 10 times, and the air purifier will turn off.
KEEPING THINGS CLEAN:
Cleaning the Air Purifier:
Wipe the outside of the air purifier with a dry cloth. Do not clean with water or any other liquid, to avoid risk of electric shock.
Check Filter Indicator
The Check Filter Indicator will light up as a reminder to check the air filters. Depending on how often you use the air purifier, the indicator should turn on within 5–7 months. You may not need to change your filters yet, but you need to check them when the indicator light turns on. Reset the Check Filter Indicator by pressing the black reset button inside the vent on the side of the air purifier.
Cleaning the Air Filters:
- The Fine Preliminary Filter should be cleaned once a month to increase efficiency and extend the life of your filter. Clean the Fine Preliminary Filter using a brush or vacuum hose to remove hair, dust, and large particles.
- Do not clean the True HEPA Filter. Fine dust or bacteria may be released back into the air if cleaning is attempted. Only clean the Fine Preliminary Filter.
- The Activated Carbon Filter does not require cleaning.
WARRANTY INFORMATION
TERMS & POLICY:
Levoit warrants all products to be of the highest quality in material, craftsmanship and service for a minimum of 2 years, effective from the date of purchase. Warranty lengths may vary between product categories. Should you encounter any issues or have any questions regarding your new product, feel free to contact our helpful Customer Support Team.
Your satisfaction is ours!
CUSTOMER SUPPORT:
Arovast Corporation 1202 N. Miller St., Suite A Anaheim, CA 92806
Email: support.eu@levoit.com
Note: To download the complete user manual, kindly click on the following link:
2 thoughts on “LEVOIT Smart WiFi User Manual”
Comments are closed.